2 Safety | 2.2 General Safety Information
ZEISS
2.2 General Safety Information
This document must be read before commissioning in order to ensure safe and uninterrupted op-
eration. Pay particular attention to all listed safety notes. Make sure, that
§
the operating personnel has read and understood this manual, associated documents and
particularly all safety regulations and instructions, and applies them.
§
the local and national safety and accident prevention regulations must be observed, as well as
the applicable laws and regulations in your country.
§
this document is always available at the place of use of the microscope.
§
the microscope is always in perfect condition.
§
the microscope is secured against access by unauthorized persons.
§
maintenance and repair work, retrofitting, removal or replacement of components, as well as
any other intervention in the microscope not described in this document, may only be carried
out by the manufacturer ZEISS or persons expressly authorized by ZEISS to do so.
2.2.1 Requirements for Operators
The microscope, components, and accessories may only be operated and maintained by autho-
rized and trained personnel. The microscope may only be used in accordance with this document.
If the microscope is not used as described, the safety of the user may be impaired and/or the mi-
croscope may be damaged.
Any unauthorized intervention or use other than within the scope of the intended use shall void
all rights to warranty claims. The regional regulations on health protection and accident preven-
tion must be observed at all times and during all work on and with the microscope.
Training
Authorized ZEISS personnel will provide basic training in operating the microscope. As well as in-
formation on equipment safety and maintenance work that can be conducted by the operator.
The training will be documented by ZEISS and its completion is to be confirmed by the operator.
Special application training is offered for a fee. Current training dates, additional information and
the registration form can be found at
https://www.zeiss.com/microscopy/int/service-support/train-
2.2.2 Safe Operating Condition
If circumstances occur which impair safety and cause changes in operating behavior, the micro-
scope must be shut down immediately and a ZEISS service representative should be informed.
The microscope may only be operated if the operating conditions are adhered to.
§
Do not operate the microscope until you have completely read and understood the entire
documentation.
§
Make sure that all protective cover panels are installed and all warning labels are available and
legible.
§
Ensure conditions and take measures to prevent the build up of electrostatic charge on the
workplace.
2.3 Prevention of Hazards
This section summarizes potential hazards and recommended safety precautions. Failure to follow
the safety instructions and instructions may result in personal injury and property damage.
2.3.1 Mechanical Hazards
Crushing Hazards
due to Motorized
Components
The microscope contains motorized components. Fingers could be trapped. Do not reach into the
working area of motorized components when they are in operation.
16
Instruction Manual ZEISS Axioscope 5, Axioscope 5/7 MAT | en-US | Rev. 13 | 430035-7344-001
