![background image](http://html2.mh-extra.com/html/zeiss/axio-observer-series/axio-observer-series_operating-manual_3338528055.webp)
INSTALLATION INSTRUCTIONS AND FIRST-TIME SET-UP
Axio Observer
Reflector turret
ZEISS
12/2016
431004-7244-001
55
4.11.2
Loading the reflector turret
To load the reflector turret with reflector modules,
it can be retracted from the stand either half-way
or completely.
•
Rotate the locking lever (Fig. 34/
2
) downwards
and raise the cover (Fig. 34/
1
).
•
Pull the reflector turret (Fig. 34/
3
) or (Fig. 35/
1
)
out of the stand to the first stop position (or
remove from the stand completely and place on
a suitable surface (stable desk).
•
Insert the reflector modules (Fig. 35/
4
) in the
relevant reflector position according to the filter
combination (see position marking Fig. 35/
6
),
starting with position 1 (emission filter is at the
bottom). To insert the reflector modules, insert
the retaining elements (Fig. 35/
5
) on the left
and right of the module into the two lower
spring clips (Fig. 35/
3
) diagonally from above,
then push the module against the upper spring
clips (Fig. 35/
2
) from the front until it clicks into
position.
•
To remove a reflector module which is not longer needed, pull it first out of the upper spring clips,
then out of the lower clips.
•
After loading, reinsert the reflector turret into the stand.
•
Close the cover and rotate the locking lever upwards.
If a protection glass for the reflector turret was supplied on first-time delivery, it will already be
mounted.
If the equipment was retrofitted, sales personnel has fitted it.
Fig. 35
Fitting the reflector modules
Summary of Contents for Axio Observer Series
Page 1: ...Axio Observer Inverted microscope Operating manual...
Page 192: ......