Rev. 3/2001 91
Chromira Air-Solenoid Installation Procedure
1.
Turn off the air supply to the Chromira. Disconnect the hose from the
exterior fitting on the Chromira.
2.
Shut down Chromira and disconnect the AC
Power Supply Cord.
3.
Locate the Motion Control Power Supply Unit
in the
lower chamber of the Chromira.
4.
Unplug the Motion Control PSU’s AC Power
Cord from the power strip at the interior of
the machine. (It should be the top-most
plug in the power strip.)
5.
Disconnect the cable that runs from the
Power Supply to the Junction board located
on the roof of the interior directly above the
power supply.
6.
Extract these cables from the troughs in
which they are routed.
7.
Take out all four screws from the top of the Power Supply case.
8.
Take out the four screws inside the Power Supply, which hold it to the floor
inside the Chromira, and remove the Power Supply from the machine.
9.
Locate the Air Inlet Hose in the end-wall of the Chromira where it enters
the interior. This is just behind where the Power Supply was mounted.
Unscrew the clamp holding the air hose onto the brass fitting.
10.
Cut into the side of the hose near the end to ease pulling it off the fitting.
Pull hose from brass nipple.
11.
Using two adjustable wrenches, unscrew the brass air inlet and remove
the part inside of the deck.
12.
Cut end of hose so that you have a nice
cut end (with no slit from step #10).
Location of Motion Control Power
Supply inside
Chromira
Screw onto
Fitting here
Connect
hose here
Air Solenoid Assembly
Unscrew
clamp
Cut into
hose
Remove
hose
Summary of Contents for CHROMIRA
