Chromira
74
1.
Shut down the Chromira Printer program if it is running.
2.
Unplug the AC Power cord from the Motor Power Supply. This is the top-most plug in
the AC power strip inside the Chromira cabinet.
3.
In the Windows START menu, go into Programs, then into Galil. Run the Galil Terminal
program.
4.
In Galil Terminal, you should see a menu bar and a large white area that says that you
are not connected with the controller.
5.
In the menu bar, click Options.
6.
In the Options menu, click the Master Reset item.
7.
A Select Controller box will appear, with the DMC-1700 listed. Click OK.
8.
A warning box will appear asking if you want to do a Master Reset. Click Yes.
9.
After about two seconds, another window will appear stating that the controller has
been master reset. Click OK.
10.
Back in the main menu bar, select the item Terminal. A window will appear that has a
white edit bar near the top, a large grey field in the middle, and some buttons along
the bottom.
11.
Click the Editor button at the bottom of this box. A small text editor window will
appear.
12.
In the text editor, click File, then Open. A standard Windows-style File Open box will
appear.
13.
Browse for the file C:\Chromira Printer\Motion Program.dmc . This is located in the
same folder as the ChromiraPrinter.EXE program. Click Open. There should now be
text in the editor window, with some rows of asterisks (*) at the top.
14.
Click File again, then Download. The menu will go away, leaving just the Editor window
again.
15.
Close the Editor window. You will now be back in the Terminal Window.
16.
Click in the white editor bar at the top of this window, and type the following
command exactly as shown, pressing Enter between each:
SCANADV=7000
<Enter> (The “SCANADV=7000” should appear in the grey area.)
XQ#INIT
<Enter>
(The “XQ#INIT” should appear in the large grey area.)
AB
<Enter>
(The “AB” should appear in the large grey area.)
ST
<Enter>
(The “ST” should appear in the large grey area.)
HX
<Enter>
(The “HX” should appear in the large grey area.)
MO
<Enter>
(The “MO” should appear in the large grey area.)
BN
<Enter>
(A brief pause, then the “BN” should appear in the large
Summary of Contents for CHROMIRA
