Rev. 3/2001 73
The Galil Motion Controller allows Chromira to operate its motors and perform the
precise movements needed for printing.
The following procedure should be performed if the Chromira Computer’s Windows
NT installation has been rebuilt using the ZBE System Recovery Disk.
1.
Start the Galil Registry program from Start Menu -> Programs -> Galil if it is not
already running (or use the Configure Galil icon on the desktop if available).
2.
In the menu bar of this program, click Registry.
3.
The Modify Registry Information window should appear showing
<No
Controllers>.
Click Add.
4.
The Set Registry Information
window will appear.
5.
Change the Model to read "DMC1700" by clicking the arrow next to the Model
box.
6.
Check that the Timeout setting is "5000" and set the Delay setting to "0".
7.
In the Bus Controller Parameters
section of this window, the Address should
read "824", the Interrupt should be "None" and the Data Record Access should
be "None".
8.
In the Win32 Device Driver section of this window, the option "Use Galil Driver"
should be selected.
9.
Click OK once all these settings are correct.
10.
The Set Registry Information window should now show "Controller1:
MC1700,Address=824"
11.
If this is the case, click Close.
12.
Re-boot the machine. This is necessary for the Galil System to initialize properly
after the above settings have been made.
Perform the following procedure after the above has been completed.
Summary of Contents for CHROMIRA
