Zato CAYMAN FCE II Series, Safety, Operation And Maintenance Manual

Page: 59 / 96

59 / 96
CAYMAN
Version 01 - Revision 00
09/05/2017
7
MaINtENaNCE INstruCtIoNs
The safety of the attachment and of the operators also depends on complying with the maintenance times
and methods�
If it is not possible to complete one of the following operations, see “7.4 troubleshooting” on
page 88 �
do not carry out maintenance while the attachment and the machine on which it is installed
are operating.
7.1
safEty MEasurEs to bE IMplEMENtEd for MaINtENaNCE
Machine maintenance must be performed exclusively by qualified personnel, as specified for
each operation to be performed.
before performing maintenance, it is mandatory to place the attachment in maintenance
status according to the following instructions, unless otherwise explicitly indicated.
use the personal protective Equipment (ppE) when indicated in the operations to be
performed.
refer to the safety data sheet of the lubricants and/or chemicals before using them.
hydraulic oil is toxic and can seriously harm people if it comes into contact with skin and/or
eyes.
failure, even in part, to follow the instructions in this manual and its accompanying documents
for maintenance on the machine voids the contractually defined warranty and relieves the
Manufacturer of any and all liability for damage and injury caused by the attachment.
It is mandatory to wear:
-
protective gloves ,
- protective non-slip shoes ,
- protective clothes ,
- protective goggles
to perform maintenance on the attachment�
Further PPE may be specified for specific operations�
do not carry out manual operations on the attachment when the machine is on�
Before any maintenance operation that does not require upper jaw movement, put appropriately sized blocks
of wood between the jaw and upper jaw to prevent the upper jaw from closing accidentally�
7.1.1
Maintenance status
To set the attachment in maintenance status , perform the following operations in order:
1� switch the machine off;
2� take the key out of the machine ignition;
3� put the key in a safe place;
4� put up a "Maintenance in progress" sign near the machine and the attachment�