Zato CAYMAN FCE II Series, Safety, Operation And Maintenance Manual

Page: 60 / 96

60 / 96
CAYMAN
Version 01 - Revision 00
09/05/2017
When maintenance has been completed, take the attachment out of maintenance status � To take the
attachment out of maintenance status , perform the following operations in order:
1� make sure that any replaced parts and tools used have been removed from the machine and the
attachment;
2� check that all the guards and protection devices possibly dismantled during the operation have been
put back in place and properly adjusted, and make sure they work correctly;
3� remove the "Maintenance in progress" sign from the attachment�
7.2
MaINtENaNCE ClassIfICatIoN
Maintenance is divided into:
∂ routine, which includes the operations set out and dealt with in this Manual;
∂ special, which includes the maintenance operations not set out or dealt with in this Manual�
Routine maintenance entails:
∂ cleaning;
∂ preventive maintenance, which includes all operations to be performed periodically so as to ensure
correct attachment operation and efficiency and prevent components from being worn;
∂ corrective maintenance, which includes all operations to be performed so as to restore correct
attachment operation following a component malfunction or breakage/wear�
further information on maintenance operations is found in the accompanying documentation
supplied.
for maintenance frequency, consider the lesser value of the two periods and the number of
working hours recommended between one intervention and another.
For cleaning, refer to “7.2.1 Cleaning” on page 60 �
For preventive maintenance, refer to “7.2.2 preventive maintenance” on page 61 �
For corrective maintenance, refer to “7.2.3 Corrective maintenance” on page 71 �
For special maintenance operations, refer to “7.2.4 special maintenance” on page 85 �
7.2.1
Cleaning
Cleaning operations must be carried out by an operator �
all cleaning operations must be done with the machine off.
do not use chemicals (such as solvents, etc�) for cleaning�
do not use compressed air for cleaning�
It is mandatory to use:
-
protective mask
to clean the attachment�
Cleaning requires generally cleaning the attachment and the cutting surfaces weekly or, if there is evident
dirt build-up, using:
∂ a metal brush for the cutting surfaces;