DOC-USR-0272-01
FSDI-1XA User’s Guide
28
a.
6.7
Setting NTP
The FSDI-1XA has support for NTP to set the time on the unit. If you require the system time to be set do
the following
(1) Load the web UI of the unit and switch to the System Setup tab. Click the go button next to Time
Settings.
(2) Select Network Time Protocol (NTP) from the Enable Time Service dropdown.
(3) Select the desired timezone for the unit form the Time Zone dropdown.
(4) Enter an NTP server address. The default is
(NIST).
(5) Click the change button. NTP is now enabled and your system clock will be adjusted.
Note:
The encoder will need to be on a network with a route to the specified NTP server and port 123 open on
the router. If the system time is not as expected check the network settings of the encoder.
Figure 31 Setting up NTP
6.8
Record to USB/Micro SD
The FSDI-1XA supports writing encoded video to a storage device connected to the USB port in .ts or
.mp4 file format. The SD card interface complies with the SD 3.0 standard, 4 bits, with support for DS,
HS, SDR12, SDR25, SDR50, SDR104, and DDR50 timing modes. So it supports UHS and UHS-I microSD
cards. The max bus speed supported is 104 MB/s.
Micro-SD cards with a double row of pins will be driven
to its max speed or to 104 MB/s if the card supports it.
Click the “+” Tab
Figure 30 Create Additional Output Channels
Connect Storage
to USB 2.0 Port
Figure 32 USB Connection
