70
is recommended that the loading/unloading slope should be less than 15°, or the
length of the ramp should be more than 3.5 times its height. When using a
mounded slope, the mounded soil should be completely compacted and measures
should be taken to prevent the slope from caving in.
6)
To prevent the machine from slipping on the ramp, remove all soil and dirt from
the tracks before starting. Make sure the ramp surface is clean and free of water,
snow, ice, grease or oil.
7)
Do not steer on the ramp or the machine will be in danger of tipping over. If you
must change the climbing path, exit the ramp, correct the direction, and then enter
the ramp again.
8)
Do not use the work device for loading and unloading, it is dangerous.
9)
When on a ramp, only maneuver the travel lever.
10)
When travelling from the ramp onto the vehicle, the machine's center of gravity
may change suddenly and there is a risk of losing balance. Therefore, travel
slowly when crossing this area.
11)
When turning the upper on the transport vehicle, the transport vehicle is unstable.
Therefore, retract the work device and turn it slowly.
12)
The wheels of the transport vehicle should be wedged when the excavator is
getting on or off.
13)
Use wooden wedges to keep the excavator in a fixed position on the transport
vehicle during transportation. Tie the excavator to the transport vehicle with a
rope strap.
14)
Before finishing the work and leaving the seat, the operator should first lift the left
control box to disconnect the pilot oil circuit to avoid malfunction of the machine
due to mistake or unintentional touching of the lever.
15)
Before going up and down the ramp, be sure to put down the positioning puller of
the rotary platform to prevent the platform from rotating.
4.15.2.
Loading
1)
Loading should only be done on solid and level ground, and keep a certain safety
distance from the edge of the road.