Chuck size: 1/4(6.35mm)+1/2(12.7mm)
Maximum
torque:
300N.m
No-load
speed:
Impact
frequency:
Net weight:
0-2800r/min
0-3200ipm
0.65kg
Specification
Adjust the fastening screw
Speed change
Gearbox operation
*Gear adjustment, high/low dual speed adjustment,
adjustable speed to cope with different working
conditions.
*The number shown is the 1st low speed gear,
which has high torque and is suitable for drilling
holes.
*The number shown is the 2nd high speed gear,
which is fast and suitable for tightening screws.
①
Action mode switching ring
②
Mark
③
Arrow
CAUTION: Be sure to set the toggle ring
correctly to the desired mode mark. The tool may
be damaged if the tool is operated with the
switching ring centered between the mode marks.
The tightening torque can be adjusted within 25
levels by turning the adjusting ring. Contrast the
arrows on the scale and tool body. When set to 1,
the tightening torque is the smallest, and when set
to 25, the tightening torque is the largest.
Before actual operation, test screws are driven
into the material or a material similar to it to
determine the torque level required for the specific
application.
Instructions
CAUTION: Before performing any assembly
operation on the tool, be sure to turn off the power to
the tool and remove the battery pack.
Correctly select the
socket/driver bit
Be sure to select the correct size impact socket for the
bolt and swing nut. Incorrectly sized impact sockets will
result in incorrect or inconsistent tightening torque or
damaged bolts or nuts.
Note: The battery pack must be removed before
operation, and it is absolutely prohibited to press the
switch button!
Caution: After inserting the screwdriver bit, make
sure it is tight. If it falls out, do not use it.
Turn the sleeve counterclockwise to open the chuck
claws, and try to put the driver bit/drill bit into the
innermost side of the chuck. Turn the sleeve
clockwise to tighten the chuck. Turn the socket
counterclockwise to remove the driver/drill bit.
①
Simple set
②
Open
③
Close
This tool has three action modes: choose the one that
suits your job. Action mode switches and aligns the
selected mark with the arrow on the tool body.
Drilling mode (rotation only);
Impact drilling mode (impact rotation);
Tightening screw mode (clutch rotation)
Screwdriver
adapter
Installation or removal of driver
bit / drill bit
Instructions
04
EN
