Yealink SIP-T40P, User Manual

Page: 31 / 188

Getting Started
19
2.
Press to select the
IPv4
and then press the
Enter
soft key.
3.
Press to select
Static IPv4 Client
and then press the
Enter
soft key.
4.
Enter the desired value in the
IP Address
,
Subnet Mask
,
Default Gateway
,
Pri.DNS
and
Sec.DNS
field respectively.
5.
Press the
Save
soft key to accept the change or the
Back
soft key to cancel.
You can configure a static IPv6 address for the IP phone. Before configuring it, make sure that
the IP mode is configured as
IPv6
or
IPv4 & IPv6
.
To configure a static IPv6 address via phone user interface:
1.
Press
Menu
->
Settings
->
Advanced Settings
(default password: admin)
->
Network
->
WAN Port
.
2.
Press to select
IPv6
and then press the
Enter
soft key.
3.
Press to select
Static IPv6 Client
and then press the
Enter
soft key.
4.
Enter the desired value in the
IP Address
,
IPv6 IP Prefix
,
Default Gateway
,
Pri.DNS
and
Sec.DNS
field respectively.
5.
Press the
Save
soft key to accept the change or the
Back
soft key to cancel.
Note
Registration
Generally, your phone will be deployed with multiple other phones. In this case, your system
administrator will configure the phone parameters beforehand, so that after you start up your
phone, the phone will be registered and ready for use. The SIP-T40P IP phone supports up to 3
accounts. If your phone is not registered, you may have to register it. For more information on
how to register your phone, refer to
Account Management on page 67 .
The wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters, contact your
system administrator.