Yealink MeetingEye 400, Administrator'S Manual

Page: 174 / 278

| Configuring Video Settings |
174
Parameter Description Configuration Method
HDMI1
Set the output resolution of
the HDMI 1 display device.
• Auto -select the highest
output resolution
automatically.
• The available output
resolutions (The available
resolutions depend on the
monitor you are using).
Default : Auto.
Web user interface
CP960 Conference Phone
HDMI 2
(it is not applicable to
MeetingEye 600/MeetingEye
400/VC200/VP59)
Enable or disable the HDMI 2
display.
Default : On.
Web user interface
HDMI2
(it is not applicable to
MeetingEye 400/VC200/
VP59)
Set the output resolution of
the HDMI 2 display device.
•
Auto
-select the highest
output resolution
automatically.
• The available output
resolutions (The available
resolutions depend on the
monitor you are using).
Default : Auto. It is
configurable only when HDMI
2 display is enabled.
Web user interface
CP960 Conference Phone
Configuring VC200 Experimental Access (Auto Framing)
The experimental access feature currently includes the auto framing, which is mainly based on face
detection. Real-time detection and position tracking are performed on all faces in the conference room. The
camera can be automatically adjusted according to the number of participants and position changes. All
participants are covered in the output screen.
About this task
Attention:
Note the following points when using the VC200 experimental access feature:
• After the auto framing is enabled, other devices cannot perform PTZ control on the VCS camera,
and the camera preset function does not take effect.
• The number of face detections on the VC200 can support up to 8 faces simultaneously in a
range of 5 meters.
• The experimental access is a new feature that Yealink is exploring. It is available to users for trial
use in advance, and may have unstable problems. It is not recommended as a daily function.
Procedure
1.
On your web user interface, go to
Security
>
Experimental Access
.