Installation and Operation Guide SOLECTRIA® PVI 25TL-208, PVI 50TL-480 and PVI 60TL-480
DOCR-071030-A (10/7/2022)
Page 98 of 131
R
UNNING
R
ECORD
This log can store up to 128 running history messages. This includes normal operating events
such as the inverter turning on, going into standby and turning off.
F
AULT
R
ECORD
This log can store up to 128 fault codes.
Device Information
Press the ESC key to leave the main “operation interface” and press ENT to access the
M
AIN
M
ENU
. Using the
arrow keys, scroll down to the
D
EVICE
I
NFORMATION
submenu and press ENT to check the device information, as
shown in Figure 6-19.
Inverter information
P1/2
Inverter Model:
Inverter SN: 0 0100 0000 0002
DSP Ver: 01.01.020×70DF DSP Boot:02.00
Data Logger Information
P2/2
IP 0.0.0.0
Data Logger SN 0 0000 0000 0000
Subnet Mask 0.0.0.0
DNS Server 0.0.0.0
Gateway 0.0.0.0
Address Range
Main Menu
Measurement Data
History Record
Power On/Off
Device Information
Setting
PmaxLim: SmaxLim:
HMI: 01.06 0×0100 HMI Boot:01.00
MiniMCU: 99.99 CPLD:15.00
Reserve
Figure 6-19
Device Information
This menu provides the information to identify the version of boards in the inverter, model number, serial number
and data logger information. This information may be required when contacting Yaskawa Solectria Solar service.
WARNING
Please follow the guidelines below before on-grid operation to eliminate possible dangers and to ensure safety.
Start-Up
Automatic start-up:
The inverter will start up automatically when the output voltage and power of PV arrays meet
the set value, AC power grid is normal, and the ambient temperature is within allowable operating range.
Manual Power ON/OFF:
Manual Power ON/OFF is required after regulation setting or manual (fault) shut-down.
Press
ESC
to and
ENT
to access the
M
AIN
M
ENU
, move the cursor to “ON/OFF” and press
ENT
. Once in the
“ON/OFF” submenu, move the cursor to “ON” and press
ENT
to start the inverter. Then the inverter will start up
and operate normally if the start-up condition is met. Otherwise, the inverter will go to stand-by mode.
