Periodic Inspection
73
2. Checking and replacing oil of each
part
[Precaution]
Keep the machine on a horizontal level while oiling.
Oiling may be insufficient if the machine is inclined.
Engine oil
<Checking>
1- Open the engine room cover
2- Pull of the dipstick and clean its front end. Push the
dipstick all the way in, and then take it out to check
whether the oil level falls between the upper limit
and lower limit of the dipstick. Fill or drain when
necessary.
Replacing
interval
First time: 50 hours
2nd time : 200 hours
After :every 200 hours
<Replacing>
1- Drain oil by taking off the drain bolt under the engine,
and add oil through the port.
2- After replacing oil, start up the engine and run at a
low speed till the oil pressure indicator is off.
3- If engine oil is insufficient, add through the oil port to
the specified level, and check any leakage.
4- After the oil pressure indicator is off, turn off the
engine, and use the dipstick to check oil level 5
minutes later. Replenish if it is insufficient.
Check and replace oil before the engine is started
up or after it is cooled down.
It will be easier to drain oil if you screw off the port
cover.
Lower
Dipstick
Upper
Oil port
Drain bolt
Oil pressure indicator
https://tractormanualz.com/yanmar/
