Driving
44
5. Loading/unloading on truck
●
Do not change the moving direction on
gangplank. Otherwise, the track may
break away from the gangplank to cause
fall-over.
●
An even and safe place without
hazardous materials around should be
selected for loading/unloading.
●
Secure the ramp boards hook to avoid
height difference with the truck body.
●
Do not stand in front of or behind the
combine to prevent dangers caused by
sudden sliding.
●
Be careful of the sudden change in gravity
center when the combine crosses the
joint between gangplank and truck.
The machine may fall over especially
when the moving speed is high. So put
the auxiliary shift lever to “Low” and
move slowly.
(Preparation of truck)
●
The parking brake of truck should be
locked, and anti-skid devices be placed
against the wheels.
Use proper saddle to support the rear part
of truck body to ensure the body strength.
Gangplank specification
Length: Over 4 times of truck body
height
Width: Over 45cm
Strength: Able to bear loads over
3000kg
Surface should be roughened and can
not be too smooth. There should be no
sharp angles to prevent damaging the
track.
[Note]
Operate as specified for traveling above.
Put the range shift lever to “Low”.
Be sure to adjust the engine speed of the
tachometer in the “Green Zone”.
Perform loading/unloading slowly in the direction of
lamp boards. Return to original position and adjust
the direction of the track deviates from the lamp
boards.
Step the brake pedal to the floor in case of sudden
stalling of engine or emergency stop.
Step the brake pedal and apply the pedal lock after
loading on truck. Fold the sunshade after engine
stalling.
Perform loading/unloading in the moving directions
listed below.
Moving
direction
Traveling
direction
Loading Forward
Unloading Reverse
●
Secure a strong rope on the “rope hook”
of the combine.
●
Be sure to keep the traveling direction of
combine in line with the direction of lamp
boards to make the track pass through
the center of lamp boards during
unloading of the combine. Additionally,
unload the combine slowly.
Over 4times of the
truck body height
Square rod
Truck body
height
Saddle
Anti-skid
device
https://tractormanualz.com/yanmar/
