Yamaha YZ 2018 Series, Owner'S Service Manual

Page: 77 / 402

CABLE ROUTING DIAGRAM
2-36
1. Battery negative lead
2. Fuel hose
3. Fuel pump coupler
4. Resistor
5. Fuel pump lead
6. Resistor coupler
7. Battery positive lead
8. Lean angle sensor
9. Starter motor lead
10. Radiator fan motor relay (blue tape)
11. Main relay (red tape)
12. Wire harness
13. Ground lead coupler
14. Starter relay coupler
15. Starter relay
16. Cross member
17. Diode
18. Fuel tank
19. Damper
20. Rear frame
21. Side cover 6
22. Plastic locking tie
A. After connecting the fuel pump coupler, attach
the coupler cover.
B. Pass the fuel hose to the front of the battery.
C. Route the resistor lead to the outside of the leads.
D. Connent the battery positive lead to the starter re-
lay terminal (in the left side of the vehicle).
E. Insert the protruding end of the wire harness into
the battery bracket hole and holder plate hole.
F. After connecting the negative lead coupler, place
it on the right side of the battery.
G. Route the diode under the cross member and
place it on top of the rear fender.
Do not let it run onto the rib of the rear fender.
H. Lower end of the rear frame
I.
Clamp it so that the lock of the plastic locking tie
faces downward, insert the end into the rear
frame and side cover 6, and then cut off the ex-
cess end. After cutting off the excess end, make
sure that the plastic locking tie does not protrude
from the lower end of the rear frame.
J. Clamp it so that the lock of the plastic locking tie
faces downward, and then pass the end between
the fuel hose and rear frame.
K. Clamp the wire harness at the position of the
white tape.
L. Route the battery positive lead under the cross
member.
M. After connecting the battery positive lead in the
direction indicated in the illustration, put the cover
on.