Yamaha YZ 2018 Series, Owner'S Service Manual

Page: 161 / 402

HANDLEBAR
4-35
5. Install:
• Engine stop switch “1”
• Clutch lever “2”
• Clutch lever holder “3”
• Clamp “4”
TIP
• The engine stop switch, the clutch lever, and
the clutch lever holder should be installed ac-
cording to the dimensions shown.
• Pass the engine stop switch lead through the
middle of the clutch lever holder.
6. Install:
• Right grip “1”
• Collar “2”
Apply adhesive to the tube guide “3”.
TIP
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface “a” with a lac-
quer thinner.
• Install the grip to the tube guide so that the
grip match mark “b” and tube guide slot “c”
form the angle as shown.
7. Install:
• Rubber cover “1”
• Throttle grip “2”
TIP
Apply the lithium-soap-based grease on the
throttle grip sliding surface.
8. Install:
• Throttle cables “1”
TIP
Slightly coat the end of throttle cable and inside
of throttle grip with lithium-soap-based grease.
Then, mount the throttle grip onto the handle-
bar.
Engine stop switch screw
0.5 N·m (0.05 kgf·m, 0.37 lb·ft)
Clutch lever holder bolt
3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
T
R
.
.
64
1
b
c
3
64