Yamaha YZ 2015 Series, Owner'S Service Manual

Page: 81 / 396

CABLE ROUTING DIAGRAM
2-38
1. Battery negative lead
2. Fuel hose
3. Fuel pump coupler
4. Fuel pump lead
5. Battery positive lead
6. Lean angle sensor
7. Starter motor lead
8. Radiator fan motor relay (blue tape)
9. Main relay (red tape)
10. Wire harness
11. Ground lead coupler
12. Starter relay coupler
13. Starter relay
14. Cross member
15. Diode
16. Fuel tank
17. Damper
18. Rear frame
19. Side cover 6
20. Plastic locking tie
A. After connecting the fuel pump coupler, attach
the coupler cover.
B. Pass the fuel hose to the front of the battery.
C. Route the battery positive lead under the cross
member.
D. Connent the battery positive lead to the starter re-
lay terminal (in the left side of the vehicle).
E. Insert the protruding end of the wire harness into
the battery bracket hole and holder plate hole.
F. After connecting the negative lead coupler, place
it on the right side of the battery.
G. After installing the plastic cover to the starter re-
lay, connect the starter relay coupler.
H. Route the diode under the cross member and
place it on top of the rear fender.
I. Lower end of the rear frame
J. Clamp it so that the lock of the plastic locking tie
faces downward, insert the end into the rear
frame and side cover 6, and then cut off the ex-
cess end. After cutting off the excess end, make
sure that the plastic locking tie does not protrude
from the lower end of the rear frame.
K. Clamp it so that the lock of the plastic locking tie
faces downward, and then pass the end between
the fuel hose and rear frame.
L. Clamp the wire harness at the position of the
white tape.