Yamaha WaveRunner FX Cruiser SHO, Service Manual

Page: 89 / 433

3-6
E
CHK
ADJ
1
2
3
4
5
6
7
8
9
5. If the throttle cable installation length
a
is
out of specification, loosen the locknut
2
,
turn the adjusting nut
3
to adjust the
length, and then tighten the locknut
2
to
the specified torque.
NOTE:
Apply locking agent to the threads of the
adjusting nut
3 .
6. Remove the handlebar cover.
Refer to “ Steering pad removal (FX SHO) ”
and “ Steering pad removal (FX Cruiser
SHO) ” in Chapter 8.
7. Slide the rubber cover
4
away from the
throttle lever.
8. Loosen the locknut
5
.
9. Turn the adjuster
6
in or out until the
specified free play is obtained.
10. Tighten the locknut 5 .
11. Squeeze the throttle lever to the fully open
position and check that the APS pulley
stopper
c
contacts the fully open stopper
d
on the APS.
12. Release the throttle lever and check that
the APS pulley stopper
e
contacts the
fully closed stopper
f
on the APS.
NOTE:
If the throttle cable free play cannot be
adjusted properly, replace the throttle cable.
13. Install the handlebar cover.
T
R
.
.
Locknut:
7 N · m (0.7 kgf · m, 5.2 ft · lb)
LOCTITE 242
Turn in Free play is increased.
Turn out Free play is decreased.
Throttle lever free play
b
:
2.0 – 5.0 mm (0.08 – 0.20 in)
T
R
.
.
Handlebar cover screw:
1 N · m (0.1 kgf · m, 0.7 ft · lb)
2
3
1
a
4 6
b
5
c
d
f
e
Control system