Yamaha WaveRunner FX Cruiser SHO, Service Manual

Page: 87 / 433

3-4
E
CHK
ADJ
1
2
3
4
5
6
7
8
9
Jet thrust nozzle QSTS angle check and
adjustment
1. Check:
• Jet thrust nozzle angle set distances
a
and
b
Difference
→
Adjust the QSTS rod joint.
NOTE:
Before measuring the jet thrust nozzle QSTS
angle make sure that the steering position of
the jet thrust nozzle is centered.
Checking steps:
1. Set the QSTS grip to the neutral position.
2. Measure the jet thrust nozzle angle set
distances
a
and
b
.
a
b
DOWN
UP
2. Adjust:
• QSTS rod joint
Adjustment steps:
1. Set the QSTS grip to the neutral position.
2. Loosen the locknut
1 .
3. Disconnect the QSTS rod joint
2
.
4. Adjust the QSTS rod joint
2
until the
upper and lower set distances
a
and
b
for the jet thrust nozzle are equal.
WARNING
The QSTS rod joint must be screwed in
more than 8 mm (0.31 in)
c
.
5. Connect the QSTS rod joint
2
to the ball
joint
3
, and then tighten the locknut
1
to
the specified torque.
Turn out Distance
a
is increased.
Turn in Distance
b
is increased.
T
R
.
.
Locknut:
4 N · m (0.4 kgf · m, 3.0 ft · lb)
a
b
DOWN
UP
3
1
2
c
Control system