Yamaha V50, Authorized Product Manual

Page: 36 / 161

6: Stereo Echo
Echo spread left/right
7: Distortion Rev.
Combination of distortion and reverb
8:
Distortion
Echo
Combination of distortion and echo
9: Gate Reverb
Reverberation with “artificially” fast cutoff
10: Reverse Gate
Reverberation simulating backwards tape playback
11: Early Ref
Adds early acoustic reflections to the sound
12: Tone Control 1
Simulated equalizer
13: Delay & Rev.
Combination of delay and reverb
14: DelayL/R & Rev.
Combination of delay L/R and reverb
15: Dist. & Delay
Combination of distortion and delay
16: Church
Reverberation simulating a church
17: Club
Reverberation simulating a music club
18: Stage
Reverberation simulating a larger live music club
19: Bath Room
Reverberation simulating a bathroom
20:
Metal
Metallic reverberation
21: Tunnel
Reverberation simulating a tunnel
22: Doubler 1
Doubling effect
23: Doubler 2
Doubling effect (spread left and right)
24: Feed Back Gate
Gate reverb with feedback
25: F. Back Reverse
Reverse gate with feedback
26: Feed Back E/R
Early reflections with feedback
27: Delay & Tone1
Combination of delay and tone control 1
28: Dly L/R & Tone1
Combination of delay L/R and tone control 1
29:
Tone Control 2
Tone control using low pass filter and high pass filter
30:
Delay & Tone2
Combination of delay and tone control 2
31:
Dly L/R & Tone2
Combination of delay L/R and tone control 2
32: Distortion
Distortion effect
Note:
Settings for “Balance”, “Out Level” and “Stereo Mix”
will vary for each effect.
(2) Effect balance
Function
Set the-volume balance of the unprocessed sound and
the effect.
Settings
0% - 100%
Explanation
As you increase the setting, the effect sound will be-
come louder. As you decrease the setting, the un-
processed sound will become louder.
Note:
At a setting of 0% the effect will not be heard, and
you will hear only the unprocessed sound. At a setting
of 100% the unprocessed sound will not be heard,
and you will hear only the sound of the effect.
Since the number keys enter two-digit numbers,
it is not possible to directly enter a value of 100. If
you need to enter a value of 100, use the data entry
slider
or
– 1/ + 1 keys after entering 99.
Effect output level, stereo mix
Press three times. (If effect select is turned
off, you will not be able to select this function.)
(1) Effect output level
Function
Set the output volume of the effect.
Performance Edit
31