Yamaha V50, Authorized Product Manual

Page: 38 / 161

Settings for 5: Delay L/R, 6: Stereo Echo Settings for 9: Gate Reverb, 10: Reverse Gate, 11: Early Ref
Parameter Settings C o m m e n t
S i z e
0.5–3.2 Specify the size of a hypothetical
room. Larger settings will cause
a more spacious effect.
LPF 1.25 KHz– Specify the low pass filter set-
12.0 KHz, thru tings. Frequencies above the
specified setting will be removed.
When “thru” is selected, this filter
will not be used.
Delay 0.1 ms–50 ms Specify the time until the effect
begins. As this setting is in-
creased, there will be a longer
wait before the delayed sound
appears.
Parameter Settings Comment
Specify the delay time for the left
channel. As this setting is in-
creased, there will be a longer
wait until the first delayed sound
from the left channel.
Specify the delay time for the
right channel. As this setting is
increased, there will be a longer
wait until the first delayed sound
from the right channel.
Specify the amount of feedback.
For a setting of 0%, there will be
only a single delayed sound.
Lch Dly 0 ms–300 ms
Rch Dly 0 ms–300 ms
FB Gain 0%–99%
Settings for 12: Tone Control Settings for 7:Distortion Rev.
Parameter Settings Comment
Time 0.3 sec–18.3 sec Specify the time it takes for the
reverb to decay. Long settings
(long reverb times) cause a
slower decay.
Dist. 0%–100% Specify the amount of distortion.
Higher settings will cause more
distortion.
Reverb 0%–100% Specify the amount of reverb.
This determines the balance of
reverb and distortion.
Settings
–12dB–+12dB
Comment
Low frequency control (shelving
band pass filter at 800Hz). Pos-
itive settings boost, and negative
settings cut.
–12dB–+12dB Middle frequency control (pres-
ence band pass filter at 1260Hz).
Positive settings boost, and ne-
gative settings cut.
–12dB–+12dB High frequency control (shelving
band pass filter at 3KHz). Positive
settings boost, and negative
settings cut.
Parameter
Low
Middle
High
Settings for 8: Distortion Echo, 15: Dist. & Delay
Parameter Settings Comment
Settings for 13: Delay & Rev.
Specify the time until the first
delayed sound. As this setting
is increased, there will be a longer
wait before the delayed sound
appears.
Specify the amount of feedback.
For higher settings, there will be
more delay repeats.
Specify the amount of distortion.
Higher settings will cause more
distortion.
Time 0 ms–300 ms
Settings Comment
Specify the time it takes for the
reverb to decay. Long settings
(long reverb times) cause a
slower decay.
Specify the delay time. As this
setting is increased, there will
be a longer wait before the de-
layed sound appears.
Parameter
RevTime
Delay
0.3 sec.–10.0 sec
FB Gain 0%–99%
Dist. 0%–100%
0 ms.–152 ms
0%.–99% FB Gain Specify the amount of delay
feedback. As this setting is in-
creased, there will be more delay
repeats.
Performance Edit
33