Yamaha SY-77, Operating Manual

Page: 116 / 268

Effect Type: Forty types of effects can be
selected for the reverb effect unit. Refer to the
list of reverb-type effects in the following section
10.4 (F2).
Effect Balance (0...100%): This determines the
balance of processed and unprocessed sound. At
a setting of 0% the output of the effect unit will
be only unprocessed sound, and at a setting of
100% the output of the effect unit will be only
processed sound.
Output Level (0...100%): This determines the
volume level of the effect output. At a setting of
0% the effect unit will output no sound, and at a
setting of 100% the output of the effect unit will
be at full volume.
To set the parameters of the selected Effect
Type, press F2 (Parm). (See the following sec-
tion 10.4 (F2).)
Remarks: Reverb effects l:Rev.Hall to
34:Distortion are mono-in stereo-out. In other
words, the incoming stereo signal from the ele-
ment Dynamic Pan is combined into a mono sig-
nal and processed to create a stereo effect.
Reverb e f f e c t s 35:Ind.Delay to
40:Ind.Rev&Delay are stereo-in stereo-out, with
independently settable parameters for left and
right.
Note: Changing the Effect Type will initialize the
Parameter settings of F2 (Parm).
VOICE EDIT MODE
10.4 (F2) Reverb effect 1 set (Parameters)
JUMP #218
COMMON DATA / EFFECT SET
Summary: Set effect parameters of the effect type
selected for reverb effect 1. This explanation
also applies to reverb effect 2.
Procedure:
From: Effect Set job directory (JUMP #211)
Select: 04:Modulation Effect 1 Set
Press: F2 (Parm) (JUMP #218)
Specify: parameter settings for the selected effect
The number and type of effect parameters will
depend on the selected Effect Type. Refer to the
following parameter lists for each effect type.
00:Off(Through) has no parameters.
To select an Effect Type and set Effect Balance
and Output level, press F1 (Data). (See the
previous section 10.4 (F1).)
Note: Changing the Effect Type in F1 (Data), will
initialize these Parameter settings.
1:Reverb Hall, 2:Reverb Room, 3:Reverb Plate,
4:Reverb Church,5:Reverb Club, 6:Reverb
Stage, 7:Reverb Bath Room, 8:Reverb Metal
Reverb Time (0.3...10.0 sec)
L.P.F. (1.25...12 KHz, Through)
Initial Delay (0.1...50 ms)
9:Single Delay
Delay Time (0.1...300 ms)
FB Delay Time (0.1...300 ms)
Feedback Gain (0...99%)
10:Delay L,R,
Lch Delay Time (0.1...300 ms)
Rch Delay Time (0.1...300 ms)
Feedback Gain (0...99%)
11:Stereo Echo
Lch Delay Time (0.1...152 ms)
Rch Delay Time (0.1...152 ms)
Feedback Gain (0...99%)
12:Doubler 1
Delay Time (0.1...50 ms)
H.P.F. (Thru, 160...1000 Hz)
L.P.F. (1.25...12 KHz, Thru)
104