Yamaha SY-77, Operating Manual

Page: 121 / 268

VOICE EDIT MODE
COMMON DATA / MICRO TUNING SET
11.1 Micro tuning data
JUMP #223
Summary: Edit the tuning for each note of the
selected micro tuning data.
Procedure:
From: Micro Tuning Edit job (JUMP #222)
directory
Select: 0 1 : M i c r o Tuning Data (JUMP #223)
Specify: the tuning for each note
The number and name of the micro tuning data
being edited are displayed.
The previous note and its absolute tuning value.
The note whose tuning you are editing.
Coarse Tuning (C#-1...G8): With the cursor
located at Coarse, adjust the tuning of the cur-
rently edited note in half steps.
Fine Tuning (-43 or -42...+42): With the cursor
located at Fine, adjust the tuning of the currently
edited note in fine steps of 1.171875 cents. The
absolute tuning value displayed in parentheses
indicates the number of these steps starting
from 0 steps at C#-2. The lowest setting of this
parameter will be either -43 or -42 depending on
the Coarse Tuning value.
The next note name and its absolute tuning
value.
Pressing F1 (K-Dn) or F2 (K-Up) will move to
the previous or next note. You can also play a
note on the keyboard to select a note at any
time.
Remarks: First use F1 (K-Dn) and F2 (K-Up) to
select the note whose tuning you want to edit.
You can also use the SY77 keyboard to select
the note. The currently edited note will appear in
the center of the display, with the previous note
shown at left and the next note shown at right.
Next set the Coarse and Tune tuning for the
selected note. If you adjust Fine Tuning beyond
the range of ±42, the Coarse Tuning will be
moved up or down as appropriate.
COMMON DATA / MICRO TUNING SET
11.2 Micro tuning name
JUMP #224
Summary: Specify a ten-character name for the
internal Micro Tuning memory being edited.
Procedure:
From: Micro Tuning Edit job (JUMP #222)
directory
Select: 02:Micro Tuning Name (JUMP #224)
Specify: a name for the micro tuning data
Enter a ten-character name for the Micro Tuning
data.
To clear the currently entered name press F1
(Clr).
To switch to upper-case characters press F2
(Uppr).
To switch to lower-case characters press F3
(Lowr).
Remarks: Methods of entering character data are
explained in Introducing the SY77, How to use
the numeric key pad, on page 30.
109