Yamaha SY-77, Operating Manual

Page: 159 / 268

VOICE EDIT MODE
AWM ELEMENT DATA
15. Initialize AWM element
Summary: Initialize the AWM Element data being
edited to a set of basic values.
Procedure:
From: AWM Element job (JUMP #256)
directory
Select: job 15:Initlz
To execute: the initialize operation press YES
To quit: without initializing press NO or EXIT
This function sets all AWM element data values to
the minimum or simplest possible setting. When
creating your own new voices it is usually best to
begin by editing an existing voice. However if you
want to start from scratch, it is often useful to start
from an initialized setting rather than having to
reset all the parameters.
If you are sure you want to initialize the AWM
element data, press YES. The AWM element data
being edited will be set to the values shown below.
If you decide not to initialize, press NO.
This function initializes only AWM element data.
Other initialize functions are provided for initializing
Voice Common data and AFM element data. Refer
to Voice Common 15. Initialize or AFM Element
15. Initialize.
Initialized settings for AWM Element data
01 AWM Waveform Select
Waveform = Preset 65
(triangle wave)
Frequency Mode = normal
Fixed Mode Note # = C3
Frequency Fine = ±0
02 AWM Amplitude EG
Mode = normal
Keyon Rates 1, 2, 3 = 6 3
KeyonRate4 = 0
KeyoffRatel = 63
Rate Scaling = ±0
Keyon Level 2, 3 = 63
03 AWM Output
Break Point 1 Note = C1
Break Point 2 Note = G2
Break Point 3 Note = E4
Break Pomt 4 Note = C6
BP1-4 Offset = +0
04 AWM Sensitivity
Velocity Sens = ±0
Rate Velocity Switch = off
AMS = 0
PMS = 3
05 AWM LFO
Wave = Triangle
Speed = 65
Delay Time = 0
AMD, PMD, FMD = 0
Init Phase = 0
06 AWM Pitch EG
Rate Scaling = ±0
Velocity Switch = off
Range = 2 octaves
Keyon Rates 1-3 = 63
Keyon Levels 0-3 = ±0
KeyoffRate 1 = 63
Keyoff Level 1 = ±0
147