Yamaha MBK MW125 2014, Service Manual

Page: 171 / 380

HANDLEBAR
4-62
EAS30203
REMOVING THE HANDLEBAR
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Handlebar grip “1”
TIP
Blow compressed air between the handlebar
and the handlebar grip, and gradually push the
grip off the handlebar.
EAS30204
CHECKING THE HANDLEBAR
1. Check:
• Handlebar
Bends/cracks/damage
→
Replace.
WARNING
EWA13690
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
2. Check:
• Brake lever cable
Damage/wear
→
Replace.
EAS30205
INSTALLING THE HANDLEBAR
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Install:
• Handlebar
TIP
• Align the slots “a” in the steering stem with the
pin “b” on the handlebar.
• After installing the handlebar, make sure that
there is a gap “c” in the handlebar.
3. Install:
• Left handlebar switch “1”
TIP
Align the projection “a” on the left handlebar
switch with the hole “b” in the handlebar.
4. Install:
• Handlebar grip “1”
• Left grip end “2”
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Apply a thin coat of a rubber adhesive to the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
T
R
.
.
Handlebar nut
53 Nm (5.3 m·kgf, 38 ft·lbf)
T
R
.
.
Handlebar switch screw (left
side)
2.4 Nm (0.24 m·kgf, 1.7 ft·lbf)
a
a
b
c
1
a
b