Yamaha F225F, Service Manual

Page: 98 / 576

3-7
RIG
GING
Rigging information
TIP:
• Make sure that the distance
g
is equal to
distance
h
.
• If the boat has a V shape hull, the center
outboard motor should have longer transom
height than the outboard motors on both
sides.
• For the distance (T1), see “Dimension” (3-
2).
2. Adjust the position of the outboard motor
so that the height of the anti-cavitation
plate
k
is equal to or slightly above the
bottom of the boat transom.
A
Single outboard motor
B
Twin outboard motor
C
Triple outboard motor
TIP:
This mounting height information is for refer-
ence only. It is impossible to provide com-
plete instructions for every possible boat and
outboard motor combination.
3. Adjust the height of the scale
m
to the
transom height (H), and place it on the
special service tool
a
. Secure the
special service tool
a
to the boat
transom using screws or vises.
TIP:
For the transom height (H), see “Dimension”
(3-2).
4. When the outboard motor mounting
position has been determined, mark the
best-suited 4 symmetrical mounting
holes in the boat transom
n
. Drill the
mounting holes perpendicular to the
surface of the boat transom using a
13.0 mm (0.5 in) drill bit.
C/L: Centerline of transom
k
A
k k
B
k
C
k
k
Drilling plate
a
: 90890-06783
Mounting hole diameter
p
:
13.0 mm (0.5 in) or more
H
C/L
m
p
a
m
n