Yamaha F225F, Service Manual

Page: 103 / 576

3-12
Installing the Digital Electronic Control box and switch panel
0
1
2
3
4
5
6
7
8
9
10
A
6. Connect the speed sensor coupler
b
.
7. Connect the extension hose
b
to the
speed sensor adapter
f
.
8. Fasten the extension hose
b
using the
plastic tie
g
.
Installing the Digital Electronic
Control box and switch panel
For the installation procedures, see the Digi-
tal network control service manual.
Installing Y-COP (optional in
non-European markets)
See the Yamaha Security System Y-COP
installation manual.
• Install the receiver so that the UP mark
is facing up.
• Do not install the receiver in a location
where it will be exposed to water.
• Do not cover the receiver with metal
objects. Otherwise, signals may not be
received.
1. Install the receiver
a
, and then tighten
the receiver screws
b
to the specified
torque.
TIP:
• Mount the receiver within 3 m (10 ft) from
the steering position.
• For installation position and drill holes, see
Yamaha Security System Y-COP installa-
tion manual.
2. Connect the Y-COP wires. See “Digital
network system diagram” (3-21).
Registering the receiver ID to the
ECM
1. Check that the engine start switch is
OFF.
f
b
b
f
g
b
Receiver screw
b
:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
b
b
a
a
Optional equipment / Installing the Digital Electronic Control box and switch panel /
Installing Y-COP (optional in non-European markets)