Xerox WorkCentre C2424/DX, Service Manual

Page: 104 / 432

3-12 WorkCentre C2424 Service Manual
4,024.42:
This fault code indicates a problem with the wiper. The wiper is not
aligned properly and engaged the headtilt while in the waste lock position.
Troubleshooting Procedure
Step Questions and Actions Yes No
1 1.
Run the Check Wiper Alignment test.
2.
Did the test fail?
Perform the
Wiper
Alignment
Procdure and
test again. Go to
Step 2 if the test
fails again. Go to Step 2.
2 1.
Run the Wiper Drive test.
2.
Did the test fail?
Go to Step 3. Go to Step 5.
3 1.
Inspect the wiper drive system and wiper
lock system. Look for ink in the belts.
2.
Is the wipe system operating correctly?
Go to Step 4. Replace the
problem
component.
4 1.
Inspect the head maintenance clutch.
2.
Is there the presence of oil or
contamination?
Clean the
interior of the
sytem and
replace clutch if
necessary. Go to Step 5.
5 1.
Run the Head Maintenance Clutch test.
2.
Is the head maintenance clutch operating
correctly?
Replace in the
following order:
■
Exit module
■
Media drive
gearbox
■
Wiper blade
Replace the
head
maintenance
clutch.