Xerox WorkCentre 4118, System Administration Manual

Page: 89 / 123

Xerox WorkCentre 4118 System Administration Guide Page 8-3
L
o
cal Conn
ection
Installation Procedure
The following drivers are provided PCL6, PostScript, Linux, Scan and ControlCentre. You can
install many of the drivers that you require at the same time.
NOTE: The drivers will be installed to the local port. For network connections, it is
recommended that you use the instructions relevant to the specific network
requirements.
The WorkCentre 4118 can be connected directly to the parallel port or USB of a host
workstation. A document file can be sent or received from the host workstation via the
appropriate port to the
WorkCentre 4118 .
There are three stages required to install the WorkCentre 4118 on a port on a local
workstation:
¾
Install the driver.
This requires the appropriate printer driver to be installed on the workstation.
¾
Workstation Setup
This requires the workstation to be configured to print to the WorkCentre
4118 .
¾
Test Print or Scan
A print job should be submitted to ensure the WorkCentre 4118 has been
installed and configured correctly.