Xerox PHASER 6121MFP, Service Manual

Page: 138 / 532

3-32 Phaser 6121MFP Service Manual
Error Messages and Codes
Error code: 0088
Definition: Received DCN signal after sending out DCS signal.
Solution:
1. Resend the fax
2. Register the telephone number in the printer.
3. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 008B
Definition: Receiver's protocol of DIS is received, but it is not compatible with our
machine.
Solution:
1. Change the machine TX speed to V.33.6, then resend again.
2. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 008D
Definition: Receiver's protocol of DIS is received, but remote side can't receive
document temporarily, may be cause by run out of paper or other reason.
Solution:
1. Contact the recipient, and ask that the machine be refilled with paper.
2. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 008F
Definition: Modem not ready to receive V.34 data within 6 seconds after
received CFR signal.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Change the machine TX speed to V.17, then resend again.
3. Print out the protocol report, and provide it to Technical Support for analysis.