Page 2-4
Xerox WorkCentre 450c/450cp Service Manual
Cyan low. START if OK,
or CARTRIDGE.
The ink supply in the cyan ink
cartridge is low.
Check the printed pages. If the print quality is
good, press
START
to clear the message and
continue using the cartridge. If the print
quality is not good, replace the cyan ink
cartridge.
Go to RAP 4.3: Ink Level Sensor on page 2-28
If long document,
START to continue. Or
press EXIT to clear
scanner jam.
The WorkCentre detected a long
document in the document tray
or there is a scanner jam.
If you are faxing a long document, press
START
. If there is a scanner jam, remove your
originals from the document tray, and then
press
EXIT/CLEAR
to clear the jam or open the
scanner cover and remove the misfed page.
Go to RAP 5.1: Doc and Read Point Sensor on page 2-
30
Ink low. START if OK or
CARTRIDGE key.
The ink in the high capacity ink
jet cartridge is low.
Check the printed pages. If the print quality is
good, press START to clear the message and
continue using the cartridge. If the print
quality is not good, replace the high capacity
ink jet cartridge.
Go to RAP 4.3: Ink Level Sensor on page 2-28
Job will start when
phone is available.
The WorkCentre is busy sending
or receiving a fax. When the
telephone line is free, the job will
start.
No action.
Go to RAP 6.1: Analog Communications on page 2-33
Job will start when
printer is available.
You tried to retrieve a document
from another fax machine when
the printer was unavailable and
the If cannot print option is set
to
do not answer.
Try again when the printer is available. Set If
cannot print to
receive to memory to retrieve
the document to memory if the printer
becomes unavailable again.
Go to RAP 3.1: Paper Feed on page 2-16
Load cartridge or color
print head.
A high capacity ink jet cartridge
or color print head is not
installed in the WorkCentre.
Install a high capacity ink jet cartridge or color
print head.
Go to RAP 4.3: Ink Level Sensor on page 2-28
Magenta low. START if
OK, or CARTRIDGE.
The ink supply in the magenta
ink cartridge is low.
Check the printed pages. If the print quality is
good, press START to clear the message and
continue using the cartridge. If the print
quality is not good, replace the magenta ink
cartridge.
Go to RAP 4.3: Ink Level Sensor on page 2-28
Memory full. Reload
unscanned pages.
The WorkCentre ran out of
memory during scanning.
Increase memory by deleting or printing the
documents stored to memory. Reload the
pages not scanned and restart the job (when
applicable).
Go to RAP 9.0: RAM Test on page 2-39
Memory full. <reason>
There isn’t enough WorkCentre
memory to complete the desired
operation
Increase memory by deleting or printing the
documents stored to memory, and then try
again.
Go to RAP 9.0: RAM Test on page 2-39
WorkCentre 450c/450cp LCD Panel Messages (Continued)
Message
Meaning
Operator Action
Technician Action
www.printcopy.info
www.printcopy.info
