Xerox 2101, User Manual, Page: 132 / 444

102
Making Copies
Added Features
Basic Features
Image Quality
Stored Job Templates
Output Format
5.6
Punching Holes
When the optional finisher is installed, this feature allows you to output copies with punched
holes.
You can select the number of punch holes from
2 Holes or 4 Holes .
●
Suitable paper sizes for punching and punch positions
The following paper sizes and positions are suitable for punching:
● Document orientation
Follow the diagram below for loading in the Head to Left orientation:
● When the punch scrap container is full, the machine will not start even if you press the Start button. Empty the punch scrap
container. For details, refer to “10.6 Emptying Punch Scrap Container”.
● When the positions for punching and stapling are in conflict (e.g. stapling on the top left and punching on the right), the machine
will not start even if you press the Start button. Check the positions again.
●
Punching cannot be carried out if tray 5 (bypass) has been selected.
● When option tray 7 is selected, punch positions are limited as follows. This limitation can be changed by means of a customer
engineer setting. Contact our Customer Support Center for details.
• When Head to Top is selected for document orientation: The left side
• When Head to Left is selected for document orientation: The top side
●
The Transparency option cannot be selected together with Repeat Image.
Position
Paper size
Top Left Right
2 Holes
B5 portrait,
A4 portrait,
8.5×11" portrait
A4, B4, A3,
11×17"
4 Holes
A4 portrait,
8.5×11" portrait
A3, 11×17"
Output
Optional
On the document glass
In the DADF