wtw OxiTop Control OC 110, Operating Manual

Page: 49 / 102

OxiTop
®
Control OC 110 Operating mode: Pressure p
ba31116e05 07/2014
49
After calling up the data of all measuring heads the controller
checks for all samples
started in the
Pressure p mode the maximum difference pres-
sure (negative or
positive) compared to the start pressure. The controller lists all
samples the value of which exceeds the amount of the differ-
ence pressure in a table (to set up the difference pressure see
section 9.4.12 L
IMIT PRESSURE
(P
RESSURE P OPERATING MODE
),
page 67).
Example list with samples the
value of which exceeds the
maximum limit pressure.
Use
<

><

> to select a sam-
ple.
The set limit pressure and the
currently measured pressure of
the sample selected are dis-
played.
Point the controller at the measuring
heads:
The allocated measuring head
flashes for approx. 5 seconds.
Then the controller displays the
pressure values again.
- Back .: Return to the list
To exit the list, press any func-
tion key.
Immediately after the data transfer of the complete measurement data
records of a finished measuring head, this measuring head is given the
free
status. The measuring head can be used for a new measurement.
The relevant sample in the sample management is marked as finished (see
section 7.5 S
AMPLE MANAGEMENT
, page 50).
RUN/ENTER
40 cm to 1 m