Sawmill Alignment
Blade Deflection
5
5-17
doc012020
Sawmill Alignment
5.10 Blade Deflection
Perform the following steps to achieve proper blade deflection with the blade guides.
1.
Raise the carriage until the blade is 15" (375 mm) above a bed rail. Measure the actual distance with
a tape from the top of the rail to the bottom of the blade.
2.
Install the blade guides. Make sure the two set screws shown are threaded into the blade guide shaft
until they touch each other.
See Figure 5-15.
3.
Loosen the bottom jam nut and tighten the top jam nut until the blade guide deflects the blade down
4.0 mm.
4.
Repeat for the other blade guide.
NOTE:
Be sure that the blade guide deflector rod clears the blade on both guide assemblies. The
rod on the outer guide assembly should be checked with the arm all the way in and all the way out.
FIG. 5-15
Sm0068b
Turn jam nuts to adjust
roller up or down
Turn jam nuts to adjust
roller up or down