SAWMILL ALIGNMENT
Blade Guide Arm Feed Chain Adjustment
SAWMILL ALIGNMENT
doc063022
6-15
6
7.
The blade guide arm should be snug, but not too tight, in the rollers. You should be able to
move it in and out with firm hand pressure. There should be no side-to-side play.
6.8
Blade Guide Arm Feed Chain Adjustment
1.
Arm and motor sprockets must be in line (see figure below). If not, loosen the set screws
and adjust the arm motor placement. Next, tighten the set screws.
2.
Check the blade guide arm chain tension. Tighten the chain if is too loose.
FIG. 6-13
Blade guide arm
sprockets and motor
sprocket must be in
line
3
Guard Adjustment Bolts
4
2
1
2
If the motor sprocket (1) is not parallel to
the blade guide arm sprockets (2), the
drive assembly may be adjusted by turning
it at a small angle around the indicated
point.
To adjust, loosen (3) bolts and use (4)
bolts.