SAWMILL ALIGNMENT
Blade Wheel Alignment
6
6-8
doc063022
SAWMILL ALIGNMENT
See Figure 6-7.
Use the cant control adjustment to adjust the idle-side blade wheel. If the
blade is too far forward on the wheel, turn the cant control counterclockwise. If it is too far
back on the wheel, turn the cant control clockwise.
10.
Check the position of the blade on the drive-side blade wheel. The blade should be
positioned on the wheel as described for the idle-side blade wheel. Adjust the drive-side
blade wheel if necessary.
See Figure 6-8.
Use the horizontal adjustment screw to adjust the drive-side blade
wheel. Loosen the jam nut on the adjustment screw. Loosen adjustment screw to move
blade out on wheel. Tighten adjustment screw to move blade in on wheel. Tighten the jam
FIG. 6-6
FIG. 6-7
150060
1 1/4"
Blade
± 1 mm (3/64”)
3.0 mm (1/8”)
1 1/4"
Blade
Cant Control
20_118
Cant Control