122
RT System 2 v2.3 Deployment Guide
R01.i
© 2010-2014 Wireless Seismic, Inc. All rights reserved.
5. Point-to-Multipoint Backhaul
Final Communication Test
b
Type
ubnt
in the User text box.
c
Type
ubnt
in the Password text box.
d
Type
80
in the Remote WEB Port text box.
e
The default test Direction is duplex; the test is performed for both transmit and
receive. If you want to run the test in only one direction, perform the following steps:
1) Select the Show Advanced Options check box.
2) Select transmit or receive.
f
Click Run Test.
g
If the following error is displayed, type 443 in the Remote WEB Port text box and
click Run Test.
Error: Invalid remote port or web server is not running.
h
Good Test Results are as follows:
Ź
RX (receive) only = 70+ Mbps
Ź
TX (transmit) only = 70+ Mbps
Ź
Total (duplex) = 90+ Mbps
–
RX = 40+ Mbps
–
TX = 40+ Mbps
7
Click another line segment radio IP address in the Select Destination IP list, click Run
Test, and then check results. Repeat for all line station radios.
8
If Speed Test results are low, perform the following steps for a Bullet radio. (Go to step
9 on page 124):
a
Log in to the line station radio that displayed low Speed Test results.
b
Click the Status tab and verify the following values:
Ź
WSI-MAX (AirMax) Quality > 80%. If the value is < 80%, check the following:
Figure 5–20 Speed Test Window
