Wintriss SmartPAC PRO, Installation Manual

Page: 54 / 92

1143200 SmartPAC PRO Installation Manual
54 Chapter 8 – SmartPAC PRO Fault Messages
If the press stops because one of the counter presets has been reached, a yellow message window like
the one shown in Figure 8-2 displays.
Figure 8-2. Counter Preset Message
When an error message displays, correct the malfunction or other problem, consulting the Problem
and Remedy descriptions for the appropriate error message in the sections that follow. When the
problem has been corrected, press Exit (or Remote Reset Button, if installed) to clear the message. If
the problem has been solved, you will be able to run the press. Otherwise, you will get the fault
message again.
If the problem persists, contact Wintriss Tech. Support. Do not attempt to run the press before
correcting the problem.
In the following sections, messages are grouped in four categories:
•
Messages that display when a counter preset is reached
•
Messages that display for equipment or brake monitor problems
•
Messages that display for programming problems
•
Messages that display when a sensor signals a fault
Counter Preset Reached Messages
“Good parts counter preset reached”
Explanation: The value set for the parts counter has been reached. The press should
stop at top dead center.
Remedy: Press RESET to clear the message. The Good Parts Count will be
automatically reset to 0.If your part run is complete, you need to change
tooling, material, etc. before you re-start the press.
“Strokes counter preset reached”
Explanation: The value set for the strokes counter has been reached. The count will be
automatically reset to 0. The press should stop at top dead center.
Remedy: Press RESET to clear the message. If your part run is complete, you need to
change tooling, material, etc. before you re-start the press.