Wintriss SmartPAC PRO, Installation Manual

Page: 31 / 92

SmartPAC PRO Installation Manual 1143200
Chapter 2 – Installing SmartPAC PRO 31
5. Wire the connector(s) to the appropriate component(s). Wire the connector(s) to the DiPro Sensor
Interface, following the instructions in
Connecting DiPro Sensor Interface to SmartPAC PRO ,
page 31.
6. Plug the connector(s) back into their sockets on the board.
7. Verify that you have installed the board(s) properly by performing the procedure in Zeroing the
Resolver , page 42. You need to complete this procedure before you can use SmartPAC PRO.
Connecting DiPro Sensor Interface to SmartPAC PRO
NOTICE
For information about using the DiProPAC, see Chapter 6, Using DiProPAC Die
Protection (Optional) , in your user manual.
To connect your DiPro die protection sensors through the DiPro Sensor Interface (DSI) 2, refer to
•
Table 2-3 to wire sensors 1-8
•
Table 2-4 to wire sensors 9-16
•
Table 2-5 to wire sensors 17-24
•
Table 2-6 to wire sensors 25-32.
Refer to wiring diagrams at the end of the manual (Figure 1 for sensors 1-16, Figure 2 for sensors 17-
32). Refer to the DSI 2 manual for more information.
Terminate cable shields as close as possible to the terminal blocks, either beneath a screw on a
standoff or to a ground stud, as described in
Terminating Cable Shields , page 18.
Figure 2-9. DiProPAC Boards (8-, 16-, and 32-Sensor): Location of Components