Wintriss SmartPAC PRO, Installation Manual

Page: 20 / 92

1143200 SmartPAC PRO Installation Manual
20 Chapter 2 – Installing SmartPAC PRO
Installing SmartPAC PRO as a Panel Mount
Follow the steps below to install the panel mount version of the SmartPAC PRO in your enclosure.
Be sure to allow at least 6 in. (152 mm) of clearance behind the panel mounting plane to leave enough
room for the electronics.
1. Determine a convenient location within your enclosure or console for mounting SmartPAC PRO.
Ideally, SmartPAC PRO should be mounted where operators and setup personnel can easily see
the readouts and reach the display.
2. Cut out a hole in your enclosure, and drill and tap twelve holes for #10-32 screws, referring to
Figure 2-2, page 20, and Figure 2-3, page 21, for mounting and “cutout” dimensions.
3. Prop the panel mount near the cutout location. You can do this by connecting ty wraps from two
of the left holes on the panel to the corresponding holes on the enclosure or console, creating
hinges.
4. Perform wiring connections as shown in the following sections. Make sure all cables will reach
the connectors on the back of the panel mount.
5. When final checkout procedures have been completed (see pages 49 - 50), install the panel mount
in your enclosure or console, using twelve #10-32 screws.
Figure 2-2 . SmartPAC PRO Panel Mount Cutout Dimension