Wintriss SmartPAC PRO, Installation Manual

Page: 55 / 92

SmartPAC PRO Installation Manual 1143200
Chapter 8 – SmartPAC PRO Fault Messages 55
“Batch # counter preset reached”
Explanation: The value set for one of the three batch counters when the output type is
set to TOP STOP has been reached. The press should stop at top dead
center. See
Setting Batch Counter Output and Increment Modes in
Chapter 5.
Remedy: Press OK to clear the message.
NOTICE
When this message appears, the corresponding batch count is automatically reset to 0.
Messages for Equipment or Brake Monitor Problems
The following messages cover resolver, input circuit, and position sensor faults, problems with the
way the press is running, brake monitor faults, and internal problems with SmartPAC PRO.
“Loss of rotation detected”
Explanation: The resolver did not start rotating within the start time limit set in Initialization
(see
SET BRAKE MONITOR in Chapter 3, SmartPAC PRO Initialization Mode ,
in your user manual.) or stopped rotating while the press was running.
SmartPAC PRO knows when the Dual Safety Valve (DSV) is energized. If it
sees that the DSV is energized but the resolver is not turning, this message
appears.
One possible cause is that the resolver’s drive belt is loose or broken. Another is
that you may have low air pressure to the clutch or a bad clutch. An internal
SmartPAC PRO problem could also have occurred, or the resolver could be
defective.
Remedy: Check the resolver, the resolver drive, and the clutch. Repair if necessary.
If these solutions do not work, an internal problem may have occurred. Call
Wintriss Tech. Support.