Wintriss SmartPAC PRO, Installation Manual

Page: 50 / 92

1143200 SmartPAC PRO Installation Manual
50 Chapter 2 – Installing SmartPAC PRO
Check the Top-stop Circuit
6. Set the stroke counter preset to a small value (e.g., 10), referring to COUNTER S in Chapter 4,
Program Mode, of your user manual; then, run the press in continuous mode until the preset value
is reached. Check to make sure that the press top-stops and that a message indicating that the
preset was reached is displayed (see Chapter 8 for counter preset messages).
•
If the press top-stopped correctly, go to step 7.
•
If the press did not top-stop and SmartPAC PRO displayed a message, there is a wiring
problem in your top-stop circuit. Recheck all wiring and trace the cause of the problem.
Check the Emergency-stop Circuit
7. Perform the 90

stop-time test to verify that the emergency-stop circuit is working, referring to
the procedure under Performing the 90° Stop-time Test in Chapter 5, Run Mode, of your user
manual.
•
If the press stops correctly, go to step 8.
•
If the press does not stop, there is a wiring problem in your emergency-stop circuit. Recheck
all wiring and trace the cause of the problem.
Check Cam Channels (ProCamPAC Only)
8. Create some test settings for your cam channels in Program mode (see Run Mode: CAM SWITCH
(ProCamPAC) in Chapter 7, ProCamPAC Instructions , in your user manual. ) , load the tool
settings, and switch to Run mode to run the press. Ensure that the equipment (feed, blow off,
lube, etc.) controlled by each channel is operating appropriately according to the settings you
made.
Test Complete
9. If you get to this step, SmartPAC PRO is working correctly. Clear any error messages by pressing
RESET, then delete the test tool. You can now create a tool in SmartPAC PRO, program settings
for it, load it, and begin to make parts using your new SmartPAC PRO.
What Next?
To program and use your SmartPAC PRO, follow the instructions in the remaining chapters of this
manual. Go to
Chapter 3, SmartPAC PRO Initialization Mode in your user manual to make
Initialization settings for your SmartPAC PRO.