Wintriss SmartPAC PRO, Installation Manual

Page: 44 / 92

1143200 SmartPAC PRO Installation Manual
44 Chapter 2 – Installing SmartPAC PRO
Figure 2-16 . Installed Options Screen (yours may list different options)
Moving the Ram to Top Dead Center (TDC)
If the ram is not at TDC, you must first inch the press to 0

± 2

before you can zero the resolver.
Since SmartPAC PRO is now connected to your stop circuits, you must load a tool in order to inch
the press.
1. Access Program mode and create a new tool, following the steps in Creating a New Tool ,
Chapter 4, SmartPAC PRO Program Mode , in your user manual.
2. Enter a counter preset of 10,000 for the tool, following the directions in COUNTERS, Chapter 4,
SmartPAC PRO Program Mode, in your user manual .
3. Load the tool, following the instructions in Loading a Tool, Chapter 4, SmartPAC PRO Program
Mode, in your user manual .
4. Turn the PROG/RUN keyswitch to RUN, and inch the press to 0

± 2

.
NOTICE
USE A DIAL INDICATOR TO DETERMINE TDC
Do not rely on the SmartPAC PRO display to indicate when the press has reached TDC. Until the
resolver is zeroed, displayed values are inaccurate. Use a dial indicator or some other means to
determine 0°.
5. When the press is at TDC, perform the next procedure.
Setting the Resolver Zero Position
To zero the resolver with the press at TDC, perform the following steps:
1. On the SmartPAC PRO Main Initialization Menu select RESOLVER ZERO. The screen shown