Wintriss SmartPAC PRO, Installation Manual

Page: 35 / 92

SmartPAC PRO Installation Manual 1143200
Chapter 2 – Installing SmartPAC PRO 35
5.
Locate the 12-conductor cable(s) for wiring the ProCamPAC board (see Figure 2-11 for layouts
of 8- and 16-channel boards) to terminal block TB301 inside the ProCamPAC Output enclosure.
If you are wiring an 8-channel ProCamPAC, one cable is supplied (for channels 1-8). If you are
wiring a 16-channel board, two cables are supplied, one for channels 1 through 8, the other for
channels 9 through 16.
Figure 2-10. ProCamPAC Boards (8- and 16-Channel): Location of Components
6. Remove the appropriate connector(s) from its socket on the ProCamPAC board (TB401 for an 8-
channel ProCamPAC, TB451 and TB452 for a 16-channel ProCamPAC). Connect wires from the
12-conductor cable(s) to the pin locations on the appropriate terminal blocks, as shown in Table
2-7 (for the 8-channel option) or Table 2-7 and Table 2-8 (for the 16-channel option). See also
wiring diagram Figure 3 at the end of the manual.