Wintriss autoset 1500, User Manual

Page: 88 / 102

1137200 AutoSet User Manual
5-4 Troubleshooting
•
The Load LED display flashes on each strain link channel at fault
•
The message “HI” or “rEP” flashes in the Setpoints LED displays for channels with a high
setpoint or repeatability fault
•
The messages “HI” and “rEP” flash alternately in the Setpoints LED display(s) for
channels with both a high setpoint and a repeatability fault
•
On AutoSet 1504 and 1504 Plus units, the Total LED display flashes
Offset Errors
AutoSet displays an offset error when one or more strain links transmit a signal that is either
too high or too low for the load analyzer to interpret accurately. Offset errors occur when a
strain link loosens, is damaged, or otherwise fails. An offset error is indicated on the front
panel as follows (see Figure 5-4, page 5-5):
•
The message “Err” flashes in the Setpoints display(s) for each strain link channel at fault
•
The message “HI” or “LO” flashes in the corresponding Load display
•
On AutoSet 1504 and 1504 Plus units, the message “Err” flashes in the Total LED display
To correct the problem:
•
Check wiring of the strain link(s) on the affected channel(s). Rewire if necessary.
•
Check mounting of the strain link. If the strain link has loosened, remount the strain link.
•
If neither of the solutions shown above fixes the problem, the strain link may be damaged
and should be replaced.
Figure 5-3. AutoSet 1504 Plus Front Panel Displaying High Setpoint and Repeatability Faults
AutoSet 1504 ®
WINTRISS LOAD ANALYZER
PLUS
SETPOINTS
RIGHT LEFT
ZERO CAM
REAR LOAD
SETPOINTS
FRONT LOAD
TOTAL
DISPLAY
HIGH
RESET REPEATABILITY
REVERSE
Flashing tonnage
value on channels
at fault
Flashing Total
tonnage value
(AutoSet 1504 only)
Flashing “HI” and
“rEP” messages
on channels at fault
Flashing “HI” and
“rEP” messages
alternate on channels
with both faults