Wintriss autoset 1500, User Manual

Page: 33 / 102

AutoSet User Manual 1137200
Installation 2-13
4.
Mount the drill jig supplied with the strain links (see Figure 2-11 for mounting
dimensions), first aligning the large hole in the jig with the mounting hole you have just
drilled and tapped, then securing the jig to the press frame with the long mounting screw.
(The four shorter screws are used to mount the strain link).
5.
Using the three smaller holes in the drill jig as guides, drill the three remaining mounting
holes. Drill the holes 1/2” deep, using a No. 7 drill bit. For metric strain links, drill 12-
mm-deep holes with a 5 mm drill bit.
6.
Remove the drill jig, and tap the three holes. Bottom tap for a 1/4-20 thread. For metric
strain links, tap with an M6X1 thread.
7.
Mount the strain link loosely on the press, using the four short mounting screws.
Figure 2-11. Strain Link Drill Jig: Mounting Dimensions
INSTALLING METRIC STRAIN LINKS
If you are installing metric strain links, the drill jig includes both a metric and a standard 1”-
long screw. The metric screw is M6X1 and is easily identified because it is made of
stainless steel and has more threads (25 vs. 20). The standard screw is 1/4-20.
0.27 DIA
(6.9)
0.21 DIA
(5.3)
3 places
4.00
(101.6)
3.00
(76.2)
0.50
(12.7)
0.44
(11.2)
0.28
(7.1)
1.00
(25.4)
Dimensions: inches
(mm)
0.75
(19.0)
NOTICE