Wintriss autoset 1500, User Manual

Page: 23 / 102

AutoSet User Manual 1137200
Installation 2-3
1.
Determine a convenient mounting location for the enclosure, considering the following
factors in addition to the ones discussed on page 2-1:
•
Ideally, the enclosure should be mounted so its top edge is at approximately chin level.
•
Mounting location must allow enough room for the door to open at least 120°.
•
Enclosure can be mounted on the press or a free-standing pedestal.
2.
Drill holes for mounting, referring to Figure 2-1 (AutoSet 1500) or Figure 2-2 (AutoSet
1504). Tap holes and mount the enclosure, using the enclosed shock mounts. Shock
mount studs are 1/4–20. Use a No. 7 drill and 1/4–20 tap.
Installing an AutoSet Panel Mount
If you have received a panel-mount version of AutoSet, perform the following steps to install
the panel mount in your enclosure or console, referring to Figure 2-3, page 2-4 for mounting
and cutout dimensions.
1.
Determine a convenient location within your enclosure or console to mount the AutoSet,
considering the factors discussed on page 2-1. The panel mount is usually installed from
outside the enclosure. Be sure to allow at least 4” (100 mm) of clearance behind the panel
mounting plane for the wiring connections.
2.
Cut out a hole in your enclosure or console, referring to Figure 2-3 for cutout dimensions.
Drill and tap fourteen holes for 1/4-20 screws, also referring to Figure 2-3.
3.
Prop the AutoSet panel mount near the cutout location (for example, by connecting ty
wraps from two of the left holes in the panel to the corresponding holes in the enclosure,
creating a hinge).
4.
Perform wiring connections as shown in the following sections. Make sure all cables will
reach the connectors on the panel mount, allowing at least 9” (230 mm) of service loop.
When the final checkout has been completed (see Final Checkout , page 3-20), install the
AutoSet panel mount in the enclosure, using fourteen 1/4-20 screws.
METRIC SHOCK MOUNTS
If you have ordered metric shock mounts with your AutoSet 1500 Plus or 1504 Plus Load
Analyzer, shock mount studs are M6X1. Use a 5 mm drill bit, and drill the holes 12 mm
deep.
NOTICE