1-4
ATTACH THE BACKBOX
6. Cut the tie-wrap that holds the 9-pin serial cable, the 25-pin parallel cable and the power/speaker
cable to the wood shipping brace. The shipping brace is held in place by two screws located on the
left and right sides of the backbox. Remove the screws and shipping brace from the backbox and
discard. See Figure 7, below.
FIGURE 7
7. Stand the backbox upright. Unlock, unscrew and remove the rear door. Pull the three cables out
through the back door opening and let them hang down the rear of the backbox. See Figure 8.
Among the parts in the cash box locate the four mounting bolts, washers and bushings, the 1/4" hex
key and the 7/32" hex key. Set these parts aside.
Backbox Assembly
25-Pin Parallel Cable
9-Pin Serial Cable to
Isolation/Speaker Cable:
2-Pin to Speakers
3-Pin to Isolation
Cabinet Assembly
Ground Strap
FIGURE 8
Summary of Contents for Pinball 2000 Star Wars Episode I
