WARNINGS & NOTICES
WARNING
FOR SAFETY AND RELIABILITY,
substitute parts and equipment modifications are not recommended. Use of Non-
WILLIAMS parts or modifications of game circuitry, may adversely affect game play, or may cause injuries.
SUBSTITUTE PART OR EQUIPMENT MODIFICATIONS
may void FCC/CANADA Type Acceptance.
BECAUSE THIS GAME IS PROTECTED
by Federal copyright, trademark, and patent laws, unauthorized game
conversions may be illegal under Federal law.
THIS ‘CONVERSION’ PRINCIPLE ALSO APPLIES
to unauthorized facsimiles of WILLIAMS equipment, logos,
designs, publications, assemblies, and games (or game features not deemed to be public domain), whether
manufactured with WILLIAMS components or not.
NOTICE
WILLIAMS, Lane-change and Multi-ball are trademarks of WILLIAMS ELECTRONICS GAMES, INC. Entire contents
of this manual © 1999 WILLIAMS ELECTRONICS GAMES, INC.
WARNING
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generated, uses, and can radiate
radio frequency energy and if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
RF Interference Notice
CABLE HARNESS PLACEMENTS and ground strap routing on this game have been designed to keep RF radiation
and conduction within levels accepted by the FCC Rules.
TO MAINTAIN THESE LEVELS, reposition harnesses and reconnect ground straps to their original placements, if
they become disconnected during maintenance.
FCC/CANADA STICKER.
Check the back of your game to verify that an FCC/CANADA certification sticker was
attached to your game at the factory. All games that leave the WILLIAMS plant have been tested and found to
comply with FCC/CANADA Rules. Because the sticker is proof of this fact, legal repercussions to the owner and
distributor may result, if the sticker is missing. If you receive a game that has no FCC/CANADA sticker, call
WILLIAMS for advice or write us a note
on your Game Registration Card. Be sure that the card bears your game’s
serial number.
For Service...
Call your authorized Williams Distributor
© 1999 Williams Electronics Games, Inc.
All Rights Reserved.
Williams Electronics Games, Inc.
3401 N. California Avenue
Chicago, IL 60618
Remember that: If you clean them, they will earn!
Mr. Squeaky Mr. Ring Mr. Bulb Mr. Flipper
Summary of Contents for Pinball 2000 Star Wars Episode I
